B2206-CURRENT VIN MISSING/MISMATCH
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
Anytime the ignition key is in the ON position.
- Set Condition:
VIN stored in Intrusion Transceiver Module does not match the VIN stored in the Cluster.
| Possible Causes |
| INTRUSION TRANSCEIVER MODULE SWAPPED FROM DIFFERENT VEHICLE |
Diagnostic Test
1.DETERMINING IF DTC IS CURRENTDoes the DTC reset?
Yes
- Using the scan tool under Miscellaneous functions initialize the Intrusion Transceiver Module.
- Perform BODY VERIFICATION TEST – VER 1 (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
No
- DTC is not active at this time. Test complete.
- Perform BODY VERIFICATION TEST – VER 1 (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)