P1602–PCM NOT PROGRAMMED

For a complete wiring diagram Refer to Section 8W.

• When Monitored:

  Ignition on and battery voltage greater than 10 volts.

• Set Condition:

  The PCM has not been programmed.

Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 9 - ENGINE - DIAGNOSIS AND TESTING).

Diagnostic Test

• Replace and program the Powertrain Control Module per Service Information.
• Perform the POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE)

• The PCM has been successfully programmed. Test is complete.
• Perform the POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE)