B168F-FRONT FOG LAMP SWITCH STUCK (SCM)
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
With the Fog Lamps on.
- Set Condition:
When the CCN detects a Fog Lamp Switch Stuck message on the BUS.
| Possible Causes |
| LIGHTING MULTIFUNCTION SWITCH |
| STEERING CONTROL MODULE |
Diagnostic Test
1.TEST FOR INTERMITTENT CONDITIONDoes the scan tool display: B168F-FRONT FOG LAMP SWITCH STUCK?
Yes
- Go To 2
No
- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
- Perform BODY VERIFICATION TEST - VER 1. (Refer to BODY VERIFICATION TEST – VER 1.
2.LIGHTING MULTIFUNCTION SWITCH
Is the resistance in each position correct?
Yes
- Replace the Steering Control Module in accordance with the service information.
- Perform the BODY VERIFICATION TEST — VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
No
- Replace the Multifunction Switch in accordance with the service information.
- Perform the BODY VERIFICATION TEST — VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)