C2201-INTERNAL CONTROLLER (FDCM)
For a complete wiring diagram Refer to Section 8W
- When Monitored:
With the ignition on.
- Set Condition:
The Final Drive Control Module has detected a failure internal to the controller.
| Possible Causes |
| FINAL DRIVE CONTROL MODULE (FDCM) |
1.FINAL DRIVE CONTROL MODULE
NOTE: This DTC may set after updating the controller software. Erase this DTC, cycle the ignition off for 10 seconds and recheck. If this DTC resets, proceed with repair procedure. If it does not reset, repair is complete.
View repair
Repair
- Replace the Final Drive Control Module in accordance with the Service Information.
- Perform the TRANSFER CASE VERIFICATION TEST-VER 1 (Refer to 21 - TRANSMISSION/TRANSAXLE/TRANSFER CASE - STANDARD PROCEDURE).