C1242-GSENSOR INPUT SIGNAL PERFORMANCE


  • When Monitored:

    Continuously after power-on reset until vehicle speed exceeds 12.4mph/20 kph for the first time, but not if the sensor voltage is out of range,

    Or, during diagnostic mode.

    Or, if the monitoring was inhibited by a corresponding diagnostics command.

    Or, if the vehicle speed has exceeded 12.4 mph/20 kph during the actual ignition cycle.

    Or, if at least one overspinning wheel is detected.

    Or, if one of the control functions is active.

  • Set Condition:

    A failure is detected if the measured acceleration signal is higher than 0.8 g longer than the specified detection time.


Possible Causes
 
WIRING HARNESS, TERMINAL, CONNECTOR DAMAGE
 
DYNAMICS SENSOR INSTALLATION
 
DYNAMICS SENSOR
 
ANTI-LOCK BRAKES MODULE
 




Diagnostic Test

1.VERIFY DTC IS ACTIVE






WARNING: Ensure brake capability is available before road testing.






Does this DTC reset?

Yes
  • Go To 2


No

2.CHECK THE DYNAMICS SENSOR INSTALLATION

NOTE: Dynamics Sensor installation and mounting bolt torque is crucial for proper operation.






Were any problems found?

Yes


No
  • Go To 3

3.INSPECT RELATED WIRING HARNESS, TERMINALS, & CONNECTORS




Were any problems found?

Yes


No
  • Go To 4

4.REPLACE DYNAMICS SENSOR & VERIFY IF DTC IS STILL ACTIVE




WARNING: Ensure brake capability is available before road testing.






Does this DTC reset?

Yes


No