INSTALLATION






CAUTION: The silver bolts retain the guides to the cylinder heads and the black bolts retain the guides to the engine block.









NOTE: The idler sprocket must be timed to the counterbalance shaft drive gear before the idler sprocket is fully seated.




NOTE: It will be necessary to slightly rotate camshafts for sprocket installation.



CAUTION: Remove excess oil from the camshaft sprocket bolt. Failure to do so can result in over-torque of bolt resulting in bolt failure.



CAUTION: Ensure the plate between the left secondary chain tensioner and block is correctly installed.


NOTE: Left and right secondary chain tensioners are not common.


CAUTION: After pulling locking pins out of each tensioner, DO NOT manually extend the tensioner(s) ratchet. Doing so will over tension the chains, resulting in noise and/or high timing chain loads.








  • primary chain idler sprocket dot is at 12 o'clock
  • primary chain crankshaft sprocket dot is at 6 o'clock
  • secondary chain camshaft sprockets “V6” marks are at 12 o'clock
  • counterbalancer shaft drive gear dot is aligned to the idler sprocket gear dot





(Refer to 9 - ENGINE/VALVE TIMING/TIMING BELT / CHAIN COVER(S) - INSTALLATION) (Refer to 9 - ENGINE/ENGINE BLOCK/VIBRATION DAMPER - INSTALLATION)
(Refer to 9 - ENGINE/CYLINDER HEAD/CYLINDER HEAD COVER(S) - INSTALLATION)

NOTE: Before installing threaded plug in right cylinder head, the plug must be coated with sealant to prevent leaks.


Mopar® Thread Sealant with Teflon


(Refer to 19 - STEERING/PUMP - INSTALLATION)
(Refer to 7 - COOLING - STANDARD PROCEDURE)