PINION DEPTH-BEARING PRELOAD-GEAR BACKLASH
The pinion gear depth is adjusted with a select shim located under the rear pinion bearing cup. Differential bearing preload and backlash is adjusted with select snap rings.
PINION DEPTH MEASUREMENT

NOTE: Take measurement with pinion shim removed and rear bearing cup in place.




DIFFERENTIAL SIDE BEARING PRELOAD

Differential side bearing preload is predetermined. Differential side bearing preload is predetermined. The select snap rings in the differential housing provides differential side bearing preload. These snap rings can be adjusted to obtain the correct ring gear backlash measurement.
If differential case, bearings or housing are replaced the differential side bearing preload select snap rings must be determined. Preload measurement is performed with Dummy Bearings 9905 and Dummy Snap Rings 9904. Each dummy snap ring is 3 mm (0.118 in) thick which must be added to the measurement.
CAUTION: Do not disturb the ELSD pump after bearing has been removed. Failure to follow these instructions will damage the pump seals.













RING GEAR BACKLASH MEASUREMENT


GEAR CONTACT PATTERN
The ring gear and pinion teeth contact patterns will show if the pinion depth is correct in the housing. It will also show if the ring gear backlash has been adjusted correctly. The backlash can be adjusted within specifications to achieve desired tooth contact patterns.
The areas on the ring gear teeth with the greatest degree of contact against the pinion teeth will squeegee the compound to the areas with the least amount of contact. Note and compare patterns on the ring gear teeth to Gear Tooth Contact Patterns chart and adjust pinion depth and gear backlash as necessary.

| GEAR CONTACT PATTERN |