C2109–DRIVETRAIN SUPPLY VOLTAGE CIRCUIT LOW





For a complete wiring diagram Refer to Section 8W.


  • When Monitored:

    Ignition on.

  • Set Condition:

    The FDCM recognizes the Switched Battery Solenoid Supply circuit voltage is too low.


Possible Causes
 
(T301) SWITCHED BATTERY SOLENOID SUPPLY CIRCUIT OPEN
 
(T301) SWITCHED BATTERY SOLENOID SUPPLY CIRCUIT SHORTED TO GROUND
 
FRONT DIFFERENTIAL SOLENOID
 
REAR DIFFERENTIAL SOLENOID
 
TRANSFER CASE MOTOR
 
FINAL DRIVE CONTROL MODULE (FDCM)
 




Diagnostic Test

1.ACTIVE DTC




Is the DTC active at this time?

Yes
  • Go To 2


No
  • Go To 8

2.(T301) SWITCHED BATTERY SOLENOID SUPPLY CIRCUIT OPEN








Is the resistance below 100 ohms?

Yes
  • Repair the open in the (T301) Switch Battery Solenoid Supply circuit.
  • Perform FDCM VERIFICATION TEST.


No
  • Go To 3

3.(T301) SWITCHED BATTERY SOLENOID SUPPLY CIRCUIT SHORTED TO GROUND







Is the resistance below 100 ohms?

Yes
  • Repair the short to ground in the (T301) Switch Battery Solenoid Supply circuit.
  • Perform FDCM VERIFICATION TEST.


No
  • Go To 4

4.FRONT DIFFERENTIAL SOLENOID OPEN



Is the resistance above 50 ohms?

Yes
  • Inspect the Front Differential Solenoid jumper harness connector, repair/replace as necessary. If OK, replace the shorted Front Differential Solenoid in accordance with the Service Information.
  • Perform FDCM VERIFICATION TEST.


No
  • Go To 5

5.REAR DIFFERENTIAL SOLENOID OPEN



Is the resistance above 50 ohms?

Yes
  • Inspect the Rear Differential Solenoid jumper harness connector, repair/replace as necessary. If OK, replace the shorted Rear Differential Solenoid in accordance with the Service Information.
  • Perform FDCM VERIFICATION TEST.


No
  • Go To 6

6.TRANSFER CASE MOTOR OPEN



Is the resistance above 50 ohms?

Yes
  • Replace the shorted Transfer Case Motor in accordance with the Service Information.
  • Perform FDCM VERIFICATION TEST.


No
  • Go To 7

7.FDCM

NOTE: Before continuing, check the FDCM harness connector terminals for corrosion, damage, or terminal push out. Repair as necessary.




Were there any problems found?

Yes
  • Repair as necessary.
  • Perform FDCM VERIFICATION TEST


No
  • Replace and program the Final Drive Control Module in accordance with Service Information.
  • Perform FDCM VERIFICATION TEST.

8.INTERMITTENT WIRING AND CONNECTORS






Were there any problems found?

Yes
  • Repair as necessary.
  • Perform FDCM VERIFICATION TEST.


No
  • Test Complete.