P0930-BTSI CONTROL CIRCUIT LOW - ESM





For a complete wiring diagram Refer to Section 8W


  • When Monitored:

    Continuously with the ignition on.

  • Set Condition:

    The DTC will set if the high side driver detects a short to ground for 10 seconds.


Possible Causes
 
ENGINE BRAKE DTCS PRESENT
 
ABS DTCS PRESENT
 
(B29) BRAKE SWITCH SIGNAL SHORT TO GROUND
 
SHIFTER LEVER ASSEMBLY
 


Always perform the NAG1 Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - NAG1 - STANDARD PROCEDURE)

Theory of Operation


The brake switch signal must be active before the shift lever can be moved out of the park position. The Shifter Lever Assembly (SLA) Electronic Shift Module (ESM) receives two brake switch signals. The first signal is a CAN C Bus message sent to the shifter lever assembly. The second signal is a hard wired brake switch signal to the shifter lever assembly. The CAN C Bus message is the primary brake switch signal and the hard wired signal serves as the backup brake switch signal.



Diagnostic Test

1.ENGINE DTCS PRESENT



Are there any Engine brake DTCs present?

Yes


No
  • Go To 2

2.ABS MODULE DTCS PRESENT



Are there any ABS DTCs present?

Yes


No
  • Go To 3

3.(B29) BRAKE SWITCH SIGNAL SHORT TO GROUND





NOTE: Check connectors - Clean/repair as necessary.




Is the resistance below 5.0 ohms?

Yes


No
  • Go To 4

4.SHIFTER LEVER ASSEMBLY



If there are no possible causes remaining, view repair.

Repair