U0019–CAN B BUS





For a complete wiring diagram Refer to Section 8W.


  • When Monitored:

    Continuously.

  • Set Condition:

    If the Can B Bus (+) or B Bus (–) circuit is open, shorted to voltage, or shorted to ground.


Possible Causes
 
CAN B BUS DTCs IN FRONT CONTROL MODULE
 
(D55) CAN B BUS (+) CIRCUIT OPEN
 
(D54) CAN B BUS (–) CIRCUIT OPEN
 
ELECTRONIC OVERHEAD MODULE
 




Diagnostic Test

1.CHECK FOR ACTIVE DTC U0019–CAN B BUS






Is DTC U0019–CAN B BUS active?

Yes
  • Go To 2


No
  • The condition that caused this code to set is not present at this time. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals.
  • Perform BODY VERIFICATION TEST VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)

2.CHECK FOR ACTIVE CAN B BUS RELATED DTCS IN THE FRONT CONTROL MODULE



Does the scan tool display any active CAN B BUS related DTCs?

Yes


No
  • Go to 3

3.CHECK (D55) CAN B BUS (+) CIRCUIT FOR AN OPEN









Is the resistance below 5.0 ohms?

Yes
  • Go To 4


No

4.CHECK THE (D54) CAN B BUS (–) CIRCUIT FOR AN OPEN





Is the resistance below 5.0 ohms?

Yes


No