B222A-VEHICLE LINE MISMATCH
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
With the ignition on.
- Set Condition:
If the Vehicle Line data transmitted on the CAN B bus doesn't correspond with the data stored in the Park Assist Module.
| Possible Causes |
| PARK ASSIST MODULE |
Diagnostic Test
1.CHECK VEHICLE LINE IN THE PCMDoes the vehicle line programmed into the PCM match the vehicle?
Yes
- Replace the Park Assist Module in accordance with the service information.
- Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
No
- The condition that caused this code to set is not present at this time. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals.
- Perform (NGC) POWERTRAIN VERIFICATION TEST (Refer to 9 - ENGINE - STANDARD PROCEDURE)