C1415- TRANSFER CASE MOTOR CURRENT PERFORMANCE
For a complete wiring diagram Refer to Section 8W
- When Monitored:
With the ignition on and no system undervoltage or overvoltage condition present.
- Set Condition:
1. Current reading greater than 1A for 200 msec with no motor activation.
2. Current reading never greater than 1A during a completed range or neutral shift.
| Possible Causes |
| TRANSFER CASE MOTOR |
| FINAL DRIVE CONTROL MODULE |
Diagnostic Test
1.DTC IS ACTIVEIs the status Active for this DTC?
Yes
- Go to 2
No
- Go to 3
2.TRANSFER CASE MOTOR
Is the DTC status Active?
Yes
- Replace the Final Drive Control Module in accordance with the Service Information.
- Perform the TRANSFER CASE VERIFICATION TEST-VER 1 (Refer to 21 - TRANSMISSION/TRANSAXLE/TRANSFER CASE - STANDARD PROCEDURE).
No
- Test complete.
- Perform the TRANSFER CASE VERIFICATION TEST-VER 1 (Refer to 21 - TRANSMISSION/TRANSAXLE/TRANSFER CASE - STANDARD PROCEDURE).
3.INTERMITTENT WIRING AND CONNECTORS
Were any problems found?
Yes
- Repair as necessary.
- Perform the TRANSFER CASE VERIFICATION TEST-VER 1 (Refer to 21 - TRANSMISSION/TRANSAXLE/TRANSFER CASE - STANDARD PROCEDURE).
No
- Test complete.