C1408-TRANSFER CASE BRAKE CONTROL CIRCUIT HIGH





For a complete wiring diagram Refer to Section 8W


  • When Monitored:

    With the ignition on and no undervoltage or overvoltage condition present.

  • Set Condition:

    The Final Drive Control Module detects that the Transfer Case Motor Lock Circuit diagnostic input is high when the output is on.


Possible Causes
 
(T317) TRANSFER CASE MOTOR LOCK SIGNAL CIRCUIT SHORTED TO VOLTAGE
 
(T317) TRANSFER CASE MOTOR LOCK SIGNAL CIRCUIT SHORTED TO THE (T301) SWITCHED BATTERY SOLENOID SUPPLY CIRCUIT
 
TRANSFER CASE MOTOR ASSEMBLY
 
FINAL DRIVE CONTROL MODULE
 




Diagnostic Test

1.DTC IS ACTIVE






Does the DTC reset?

Yes
  • Go to 2


No
  • Go to 5

2.(T317) TRANSFER CASE MOTOR LOCK SIGNAL CIRCUIT SHORTED TO VOLTAGE









Is there any voltage present?

Yes


No
  • Go to 3

3.(T317) TRANSFER CASE MOTOR LOCK SIGNAL CIRCUIT SHORTED TO THE (T301) SWITCHED BATTERY SOLENOID SUPPLY CIRCUIT






Is the resistance below 5.0 ohms?

Yes


No
  • Go to 4

4.TRANSFER CASE MOTOR







Does the DTC P1408-Transfer Case Brake Control Circuit High set?

Yes


No

5.INTERMITTENT WIRING AND CONNECTORS






Were any problems found?

Yes


No
  • Test complete.