P0563-BATTERY VOLTAGE HIGH





For a complete wiring diagram Refer to Section 8W

Theory of Operation


The Transmission Control Module (TCM) monitors ignition voltage. The DTC will set and temporary limp-in will be activated, if the monitored battery voltage rises above 16.9 volts. If the voltage drops below 16.4 volts, normal operations is resumed and the TCM will record the DTC as a one trip fault. The DTC will only mature to a full DTC if the voltage rises above 16.9 volts with a engine speed greater than 2000 RPM for a least 60 seconds.


  • When Monitored:

    Continuously with the ignition on.

  • Set Condition:

    When the monitored battery voltage rises above 16.9 volts.


Possible Causes
 
CHARGING SYSTEM OVERCHARGE CONDITION
 
JUMP START OFF A 24 VOLT SYSTEM
 
TRANSMISSION CONTROL MODULE
 


Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - NAG1 - STANDARD PROCEDURE)



Diagnostic Test

1.CHECK FOR CHARGING SYSTEM DTCS


NOTE: This includes any one trip faults.



Are there any Engine Charging System DTCs present?

Yes


No
  • Go To 2

2.CHECK IF VOLTAGE IS GREATER THAN 16.9 VOLTS




Does the Transmission system voltage read above 16.9 volts for any period of time?

Yes
  • Go To 4


No
  • Go To 3

3.VERIFY IF VEHICLE WAS JUMP STARTED WITH 24-VOLT SYSTEM



Was the vehicle jump started by another vehicle using a 24-volt charging system?

Yes


No
  • Go To 5

4.CHECK BATTERY VOLTAGE








Does the voltage readings match between the Transmission scan tool reading and the battery voltmeter reading?

Yes
  • Repair the charging system for an over charging condition. Refer to the 9 - ENGINE ELECTRICAL DIAGNOSTICS and diagnose the appropriate symptom as if the DTC is current.


No
  • Using the schematics as a guide, check the Transmission Control Module (TCM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the TCM per the Service Information. Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES/TRANSMISSION CONTROL MODULE for the appropriate service procedures.
  • Perform NAG1 TRANSMISSION VERIFICATION TEST. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - NAG1 - STANDARD PROCEDURE)

5.INTERMITTENT WIRING AND CONNECTORS





Were there any problems found?

Yes


No
  • Test Complete.