B2204-ECU CONFIGURATION MISMATCH

For a complete wiring diagram Refer to Section 8W.

• When Monitored:

  With the ignition switch on.

Diagnostic Test

NOTE: Before continuing review and check the following conditions.

• Review the repair history of the vehicle. Ensure the vehicle has the correct PCM and SKREEM installed. Check the part numbers.
• Using a scan tool, ensure the PCM and SKREEM have been programmed correctly. Compare the PCM VIN to the SKREEM VIN and ensure the two VINS match.

• Replace and program the SKREEM in accordance with the Service Information.

  NOTE: If this vehicle is equipped with a Steering Column Lock Module, it must be replaced along with the SKREEM.

• Perform SKREEM VERIFICATION TEST. (Refer to 8 - ELECTRICAL/VEHICLE THEFT SECURITY - STANDARD PROCEDURE)

• The DTC is not active at this time. Test complete.