U1000–CAN B BUS (+) CIRCUIT– DDM – PDM





For a complete wiring diagram Refer to Section 8W.


  • When Monitored:

    With the ignition in the run position.

  • Set Condition:

    If the Driver/Passenger Door Module senses that the (D55) Can B Bus (+) circuit is either open, or shorted to voltage, or shorted to ground.


Possible Causes
 
FOR THE DRIVER MEMORY MIRROR SYSTEM:
 
ACTIVE CAN B BUS DTCs IN FRONT CONTROL MODULE (FCM)
 
(D55) CAN B BUS (+) CIRCUIT OPEN TO DRIVER DOOR MODULE
 
DRIVER DOOR MODULE
 
FOR THE PASSENGER MEMORY MIRROR SYSTEM:
 
ACTIVE CAN B BUS DTCs IN FRONT CONTROL MODULE (FCM)
 
(D55) CAN B BUS (+) CIRCUIT OPEN TO PASSENGER DOOR MODULE
 
PASSENGER DOOR MODULE
 


NOTE: Since this DTC can set in the Driver Door Module (DDM) and in the Passenger Door Module (PDM) this procedure addresses both systems' circuits and components. Select only that which applies to the system you are diagnosing.



Diagnostic Test

1.TEST FOR INTERMITTENT CONDITION







Does the scan tool display: U1000 CAN B BUS (+) CIRCUIT?

Yes
  • Go To 2


No

2.CHECK FOR ACTIVE CAN B BUS RELATED DTCS IN THE FRONT CONTROL MODULE (FCM)



Does the scan tool display any active CAN B BUS related DTCs?

Yes


No
  • Go To 3

3.CHECK THE (D55) CAN B BUS (+) CIRCUIT FOR AN OPEN BETWEEN THE FRONT CONTROL MODULE & THE DRIVER / PASSENGER DOOR MODULE



For the Driver Memory Mirror System, proceed as follows:
  • Turn the ignition off.
  • Disconnect the Driver Door Module C2 connector.
  • Disconnect the Front Control Module C1 connector.
  • Measure the resistance of the (D55) Can B Bus (+) circuit between the Front Control Module C1 connector and the Driver Door Module C2 connector.

For the Passenger Memory Mirror System, proceed as follows:
  • Turn the ignition off.
  • Disconnect the Passenger Door Module C2 connector.
  • Disconnect the Front Control Module C1 connector.
  • Measure the resistance of the (D55) Can B Bus (+) circuit between the Front Control Module C1 connector and the Passenger Door Module C2 connector.


Is the resistance below 2.0 ohms?

Yes, Driver Mirror


Yes, Passenger Mirror


No