U1108-ADDITIONAL CAN B ECU DETECTED
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
Continuously.
- Set Condition:
The Front Control Module detects an additional CAN B module and requires a reconfiguration.
| Possible Causes |
| ADDITIONAL MODULE ADDED/REMOVED FROM THE CAN B BUS NETWORK |
Diagnostic Test
1.RECONFIGURE THE FRONT CONTROL MODULEDoes the scan tool display this DTC as active?
Yes
- Retest system and attempt to reconfigure the FCM.
- Perform BODY VERIFICATION TEST – VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE).
No
- Repair is complete.
- Perform BODY VERIFICATION TEST – VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE).