B222C-VEHICLE CONFIGURATION NOT PROGRAMMED

For a complete wiring diagram Refer to Section 8W.

When Monitored:
With the ignition on.
Set Condition:
The Front Control Module is not configured correctly to the vehicle.

Possible Causes

FRONT CONTROL MODULE NOT CONFIGURED CORRECTLY

FRONT CONTROL MODULE

1.CHECK FOR ACTIVE DTC

Does the scan tool display this DTC as active?

Yes

If the DTC is stored, check for an intermittent condition. Visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals.

2.CONFIGURE THE FCM TO THE VEHICLE

Does the scan tool display this DTC as active?

Yes

Inspect the wiring and connectors for damage or shorted circuits. If ok, replace and program the Front Control Module in accordance with the service information.
Perform BODY VERIFICATION TEST – VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE).