35–FAILED COOL DOWN (MTC)

For a complete wiring diagram Refer to Section 8W.


  • When Monitored:

    When the Cooldown Test is executed.

  • Set Condition:

    If the A/C system is unable to lower the evaporator temperature 11.11°C (20°F).


Possible Causes
 
PREREQUISITES NOT MET BEFORE RUNNING THE COOLDOWN TEST
 
ANOTHER RELATED SYSTEM NOT FUNCTIONING CORRECTLY
 
POWERTRAIN SYSTEM FAULTS PRESENT
 


NOTE: This DTC will display as active if the ignition is not cycled after running the Cooldown Test. Otherwise, it will display as stored until cleared.



Diagnostic Test

1.VERIFY THAT ALL OF THE COOLDOWN TEST PREREQUISITES WERE MET


  • DTC 31 or 32 must not be active.
  • The refrigerant system must be adequately charged.
  • The blower motor must operate correctly in all speeds.
  • The work area ambient temperature must be above 18.3°C (65°F).
  • The evaporator temperature must be above 18.3°C (65°F).
  • The A/C compressor must be turned off.


Were all of the prerequisites met before running the Cooldown Test?

Yes
  • Go To 2


No

2.CHECK FOR DTCs IN THE PCM



Are any DTCs present in the PCM?

Yes


No