Installation


NOTE: If equipped with a PTU, install the O-ring into the PTU.
(Refer to 21 - TRANSMISSION/TRANSAXLE/POWER TRANSFER UNIT - INSTALLATION)

NOTE: Do not install the rear transmission mount through bolt at this time.
(Refer to 8 - ELECTRICAL/STARTING/STARTER MOTOR - INSTALLATION)


NOTE: Insure that the metallic gasket is in place.

(Refer to 3 - DIFFERENTIAL & DRIVELINE/PROPELLER SHAFT - INSTALLATION)
NOTE: Never let propeller shaft hang with out support.
(Refer to 3 - DIFFERENTIAL & DRIVELINE/HALF SHAFT - INSTALLATION)
(Refer to 21 - TRANSMISSION/TRANSAXLE/MANUAL/FLUID - STANDARD PROCEDURE)
(Refer to 21 - TRANSMISSION/TRANSAXLE/POWER TRANSFER UNIT - STANDARD PROCEDURE)


NOTE: The cable with the green clip is the inboard cable.

(Refer to 6 - CLUTCH - STANDARD PROCEDURE)


