POWER MIRRORS


WIRING VOLTAGE TEST (LHD)

The following wiring test determines whether or not voltage is continuous through the body harness to switch.




If the test light illuminates, the wiring circuit between the battery and switch is OK.

If the lamp does not illuminate, first check fuse 18 in the Junction Block (JB). If fuse 18 is OK, then check for a broken wire.

Refer to the appropriate wiring information.


POWER MIRROR MOTOR TEST (LHD)

If the power mirror switch is receiving proper current and ground and mirrors do not operate, proceed with power mirror motor test. Refer to the appropriate wiring information.



  • Connect one to a 12 volt source
  • Connect the other to a good body ground
  • Refer to the Mirror Motor Test Chart for proper wire connections at the switch connector.

MIRROR MOTOR TEST CHART

12 VOLTS
 
GROUND
 
MIRROR REACTION
 
SWITCH CONNECTOR
 
RIGHT
 
LEFT
 
 
PIN 4
 
PIN 1
 
-
 
UP
 
PIN 8
 
PIN 1
 
-
 
LEFT
 
PIN 1
 
PIN 4
 
-
 
DOWN
 
PIN 1
 
PIN 8
 
-
 
RIGHT
 
PIN 9
 
PIN 10
 
UP
 
-
 
PIN 2
 
PIN 10
 
LEFT
 
-
 
PIN 10
 
PIN 9
 
DOWN
 
-
 
PIN 10
 
PIN 2
 
RIGHT
 
-