TIPM–B2337–HORN CONTROL CIRCUIT HIGH





For a complete wiring diagram Refer to Section 8W


  • When Monitored:

    With the ignition on. Battery voltage greater than 10.4 volts.

  • Set Condition:

    A shorted high condition in the (X21)/(X22) Horn Control Output circuit.


Possible Causes
 
(X21) HORN CONTROL OUTPUT CIRCUIT SHORTED TO BATTERY VOLTAGE
 
(X22) HORN CONTROL OUTPUT CIRCUIT SHORTED TO BATTERY VOLTAGE (EXPORT)
 
EXCESSIVE RESISTANCE IN THE HORN OR CASE GROUND
 
TOTALLY INTEGRATED POWER MODULE
 




Diagnostic Test

1.CHECK FOR ACTIVE DTC B2337 – HORN CONTROL CIRCUIT HIGH IN THE TIPM






Does the scan tool display active DTC B2337–HORN CONTROL CIRCUIT HIGH?

Yes
  • Go To2


No
  • The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.

2.CHECKING THE HORN(S)





Did the horn(s) operate properly?

Yes
  • Go To 4


No
  • Go To3

3.CASE GROUND CIRCUIT OPEN



Does the test light illuminate brightly?

Yes


No

4.(X21)/(X22) HORN CONTROL OUTPUT CIRCUIT SHORTED TO BATTERY VOLTAGE








Is there any voltage present?

Yes


No
  • Go To 5

5.TOTALLY INTEGRATED POWER MODULE

NOTE: Before continuing, check the TIPM harness connector terminals for corrosion, damage, or terminal push out. Repair as necessary.





Were any problems found?

Yes


No