B106B–REAR DEFROST CONTROL CIRCUIT LOW (TIPM)





For a complete wiring diagram Refer to Section 8W.


  • When Monitored:

    With the ignition on. Battery voltage greater than 10.4 volts.

  • Set Condition:

    A shorted low condition on the (C515) Rear Defogger Control Output or (C16) Fused Rear Defogger Control Output circuit.


Possible Causes
 
(C515) REAR WINDOW DEFOGGER CONTROL OUTPUT CIRCUIT SHORTED TO GROUND
 
(C16) FUSED REAR WINDOW DEFOGGER CONTROL OUTPUT CIRCUIT PARTIAL SHORT TO GROUND (IF EQUIPPED WITH HEATED MIRRORS)
 
HEATED MIRRORS (IF EQUIPPED)
 
TIPM
 




Diagnostic Test

1.VERIFY DTC B106B–REAR DEFROST CONTROL CIRCUIT LOW IS ACTIVE






Does the scan tool display active DTC B106B-REAR DEFROST CONTROL CIRCUIT LOW?

Yes
  • Go To 2


No

2.INSPECT (C515) REAR WINDOW DEFOGGER CONTROL OUTPUT CIRCUIT AT REAR WINDOW GRID




Were there any problems found?

Yes


No
  • Go To 3

3.VEHICLE EQUIPPED WITH HEATED MIRRORS


Is this vehicle equipped with heated mirrors?

Yes
  • Go To 4


No
  • Go To6

4.DISCONNECT MIRROR AND RE-CHECK DTC

NOTE: For this step disconnect each outside rearview mirror one at a time and re–check DTC's.






Does the scan tool display active DTC B106B-REAR DEFROST CONTROL CIRCUIT LOW?

Yes
  • Go To 5


No

5.(C16) FUSED REAR WINDOW DEFOGGER CONTROL OUTPUT CIRCUIT SHORTED TO GROUND








Is the resistance below 100 ohms?

Yes


No
  • Go To 6

6.(C515) REAR WINDOW DEFOGGER CONTROL OUTPUT CIRCUIT SHORTED TO GROUND








Is the resistance below 100 ohms?

Yes


No
  • Go To 7

7.TOTALLY INTEGRATED POWER MODULE

NOTE: Before continuing, check the TIPM harness connector terminals for corrosion, damage, or terminal push out. Repair as necessary.





Were any problems found?

Yes


No