C151D-TIRE PRESSURE SENSOR LOCATION UNDETERMINED

For a complete wiring diagram Refer to Section 8W.

Theory of Operation


The vehicle sensor locate process occurs after the vehicle sits at zero speed for more than 19 min. The tire pressure monitor system will determine the sensor positions while driving at speeds above 15 MPH (24 Km/h). This process can take up to 10 min. to determine sensor positions.


  • When Monitored:

    During vehicle sensor locate process.

  • Set Condition:

    Must fail vehicle sensor locate process 3 times in a row.


Possible Causes
 
(D508) COM - LIN TIRE PRESSURE MONITOR LAN CIRCUIT SHORT TO VOLTAGE
 
(D508) COM - LIN TIRE PRESSURE MONITOR LAN CIRCUIT SHORT TO GROUND
 
(D508) COM - LIN TIRE PRESSURE MONITOR LAN CIRCUIT OPEN OR HIGH RESISTANCE
 
FUSED IGNITION SWITCH OUTPUT (RUN) CIRCUIT OPEN OR HIGH RESISTANCE
 
GROUND CIRCUIT(S) OPEN OR HIGH RESISTANCE
 
(D508) COM-LIN TIRE PRESSURE MONITOR LAN CIRCUIT OPEN
 
TIRE PRESSURE TRIGGER MODULE POWER AND GROUND
 
TPM SENSOR
 
WCM
 




Diagnostic Test

1.OTHER DTC'S SET



Is this DTC still active after all other DTC's repaired?

Yes
  • Go To 2


No

2.VERIFY DTC IS ACTIVE

NOTE: Ensure the IOD fuse is installed and battery voltage is between 10 and 16 volts before proceeding.








Does this DTC reset?

Yes
  • Go To 3


No

3. (D508) COM-LIN TIRE PRESSURE MONITOR LAN CIRCUIT OPEN






Is the resistance below 5 Ohms?

Yes
  • Go To 4


No

4.








NOTE: The test light should be illuminated and bright. Compare the brightness to that of a direct connection to the battery.



Is the test light illuminated and bright?

Yes
  • Go to 5


No

5.




NOTE: The test light should be illuminated and bright. Compare the brightness to that of a direct connection to the battery.



Does the test light illuminate brightly?

Yes
  • Go to 6


No

6.






Is there any voltage present?

Yes
  • Repair the (D508) COM - LIN Tire Pressure Monitor LAN circuit for a short to voltage.


No

7.






Is the resistance below 5.0 ohms?

Yes


No
  • Go to 8

8.





NOTE: The test light should be illuminated and bright. Compared the brightness to that of a direct connection to the battery.



Does the test light illuminate bright?

Yes
  • Go to 9


No

9.POWER AND GROUND CIRCUIT OPEN




Is the voltage at least the same as battery voltage?

Yes


No

10.CHECK FOR ADDITIONAL TRIGGER MODULE COMMUNICATION RELATED DTCs



Is there more than one module with active DTCs “Logged Against” the WCM?

Yes


No