P0683-GLOW PLUG CONTROL MODULE TO PCM COMMUNICATION





For a complete wiring diagram Refer to Section 8W


  • When Monitored:

    With the ignition on.

  • Set Condition:

    The ECM detects a fault on the (D330) Glow Plug Module Signal circuit for 0.5 second.


Possible Causes
 
INTERMITTENT DTC
 
(D330) GLOW PLUG MODULE SIGNAL CIRCUIT SHORTED TO GROUND
 
(D330) GLOW PLUG MODULE SIGNAL CIRCUIT OPEN OR HIGH RESISTANCE
 
(K202) GLOW PLUG RELAY CONTROL CIRCUIT OPEN OR HIGH RESISTANCE
 
(D330) GLOW PLUG MODULE SIGNAL CIRCUIT SHORTED TO VOLTAGE
 
GLOW PLUG MODULE
 


Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 9 - ENGINE - DIAGNOSIS AND TESTING)



Diagnostic Test

1.DTC IS ACTIVE











Is the status Active for this DTC?

Yes
  • Go To 2


No

2.(D330) GLOW PLUG MODULE SIGNAL CIRCUIT SHORTED TO GROUND








Is the resistance below 1000 ohms?

Yes


No
  • Go to 3

3.(D330) GLOW PLUG MODULE SIGNAL CIRCUIT OPEN OR HIGH RESISTANCE





Is the resistance below 10.0 ohms?

Yes
  • Go To 4


No

4.(K202) GLOW PLUG RELAY CONTROL CIRCUIT OPEN OR HIGH RESISTANCE





Is the resistance below 10.0 ohms?

Yes
  • Go To 5


No

5.(D330) GLOW PLUG MODULE SIGNAL CIRCUIT SHORTED TO VOLTAGE








Is the voltage above 1.0 volt?

Yes


No