P0182-FUEL TEMPERATURE SENSOR CIRCUIT LOW





For a complete wiring diagram Refer to Section 8W


  • When Monitored:

    With the ignition on.

  • Set Condition:

    The (K156) Fuel Temperature Sensor Signal circuit voltage is below 0.41 volts.


Possible Causes
 
INTERMITTENT DTC
 
(K156) FUEL TEMPERATURE SENSOR SIGNAL CIRCUIT SHORTED TO GROUND
 
(K156) FUEL TEMPERATURE SENSOR SIGNAL CIRCUIT SHORTED TO (K900) FUEL TEMPERATURE SENSOR GROUND
 
FUEL TEMPERATURE SENSOR
 
ENGINE CONTROL MODULE (ECM)
 


Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 9 - ENGINE - DIAGNOSIS AND TESTING)



Diagnostic Test

1.DTC IS ACTIVE









Is the status Active for this DTC?

Yes
  • Go To 2


No

2.FUEL TEMPERATURE SENSOR






NOTE: The scan tool should display a Fuel Temperature Sensor High voltage or open circuit DTC with the Fuel Temperature Sensor connector disconnected.



Does the scan tool display the DTC(s) as described above?

Yes


No
  • Go to 3

3.(K156) FUEL TEMPERATURE SENSOR SIGNAL CIRCUIT SHORTED TO GROUND







Is the resistance above 1000 ohms?

Yes
  • Go to 4


No

4.(K156) FUEL TEMPERATURE SENSOR SIGNAL CIRCUIT SHORTED TO (K900) FUEL TEMPERATURE SENSOR GROUND CIRCUIT





Is the resistance above 1000 ohms?

Yes
  • Go to 5


No

5.ENGINE CONTROL MODULE (ECM)








Were any problems found?

Yes


No