*CHECKING THE TEMPERATURE SENSORS

For a complete wiring diagram Refer to Section 8W.
Diagnostic Test
1.COMPARE TEMPERATURE SENSOR VALUESAre all temperature sensor values within 10° C (18° F) of the thermometer and the other sensor values?
Yes
- Test complete.
No
- Go to 2
2.TEMPERATURE SENSOR WIRING OR CONNECTORS
NOTE: Perform the following procedures for each sensor that was not within the specified range as described in the previous step.
Were any problems found?
Yes
- Repair as necessary in accordance with the Service Information.
- Perform the PCM Verification Test. (Refer to 9 - ENGINE - STANDARD PROCEDURE)
No
- Go to 3
3.SENSOR VOLTAGE
NOTE: The sensor voltage should be approximately 0.0 volts (plus or minus .1 volt) with the jumper wire in place.
Does the scan tool display the voltage as described above?
Yes
- Go to 4
No
- Go to 5
4.TEMPERATURE SENSOR
NOTE: The sensor voltage should be approximately 5.0 volts (plus or minus .1 volt) with the connector disconnected.
Does the scan tool display the voltage as described above?
Yes
- Replace the sensor.
- Perform the PCM Verification Test. (Refer to 9 - ENGINE - STANDARD PROCEDURE)
No
- Go to 5
5.SIGNAL CIRCUIT SHORTED TO GROUND
Is the resistance above 100 ohms?
Yes
- Go to 6
No
- Repair the signal circuit for a short to ground.
- Perform the PCM Verification Test. (Refer to 9 - ENGINE - STANDARD PROCEDURE)
6.SIGNAL CIRCUIT SHORTED TO SENSOR GROUND CIRCUIT
Is the resistance above 100 ohms?
Yes
- Go to 7
No
- Repair the signal circuit for a short to the sensor ground circuit.
- Perform the PCM Verification Test. (Refer to 9 - ENGINE - STANDARD PROCEDURE)
7.SIGNAL CIRCUIT HIGH RESISTANCE
CAUTION: Do not probe the PCM harness connectors. Probing the PCM harness connectors will damage the PCM terminals resulting in poor terminal to pin connection. Install Miller Special Tool #8815 along with the #8815-1 to perform the diagnosis.
WARNING: When the engine is operating, do not stand in direct line with the fan. Do not put your hands near the pulleys, belts, or fan. Do not wear loose clothing. Failure to follow these instructions can result in personal injury or death.
Is the voltage below 0.5 volts?
Yes
- Go to 8
No
- Repair the signal circuit for high resistance.
- Perform the PCM Verification Test. (Refer to 9 - ENGINE - STANDARD PROCEDURE)
8.SENSOR GROUND CIRCUIT HIGH RESISTANCE
CAUTION: Do not probe the PCM harness connectors. Probing the PCM harness connectors will damage the PCM terminals resulting in poor terminal to pin connection. Install Miller Special Tool #8815 along with the #8815-1 to perform the diagnosis.
WARNING: When the engine is operating, do not stand in direct line with the fan. Do not put your hands near the pulleys, belts, or fan. Do not wear loose clothing. Failure to follow these instructions can result in personal injury or death.
Is the voltage below 0.5 volts?
Yes
- Go to 9
No
- Repair the sensor ground circuit for high resistance.
- Perform the PCM Verification Test. (Refer to 9 - ENGINE - STANDARD PROCEDURE)
9.MODULE
Were any problems found?
Yes
- Repair as necessary.
- Perform the PCM Verification Test. (Refer to 9 - ENGINE - STANDARD PROCEDURE)
No
- Replace the applicable control module in accordance with the Service Information.
- Perform the PCM Verification Test. (Refer to 9 - ENGINE - STANDARD PROCEDURE)