*CHECKING THE FUEL DELIVERY SYSTEM
For a complete wiring diagram Refer to Section 8W.
Diagnostic Test
1.CHECKING THE FUEL PUMP OPERATIONNOTE: Diagnose and repair any fuel pump control circuit or relay DTCs before continuing with this test.
NOTE: It may be necessary to use a mechanics stethoscope in the next step.
NOTE: If the pump has excessive noise or grinding, the pump should be replaced.
CAUTION: Stop all actuation tests before continuing.
Is the fuel pump operating when actuated?
Yes
- Go to 2
No
- Go to 7
2.CHECKING THE FUEL PRESSURE
WARNING: The fuel system is under a constant pressure even with the engine off. Before testing or servicing any fuel system hose, fitting or line, the fuel system pressure must be released. Failure to follow these instructions can result in personal injury or death.
NOTE: The fuel pressure specification is 407 KPa +/- 34 KPa (59 psi +/- 5 psi).
CAUTION: Stop all actuation tests before continuing.
Select the conclusion that best matches the result of the test:
Fuel pressure is within the stated specification
- Test complete.
Fuel pressure is below the stated specification
- Go to 3
Fuel pressure is above the stated specification
- Replace the fuel filter/pressure regulator.
- Perform the PCM Verification Test. (Refer to 9 - ENGINE - STANDARD PROCEDURE)
3.RESTRICTED FUEL SUPPLY LINE
WARNING: The fuel system is under a constant pressure, even with the engine off. Before testing or servicing any fuel system hose, fitting or line, the fuel system pressure must be released. Failure to follow these instructions can result in personal injury or death.
NOTE: Fuel pressure specification is 407 KPa +/- 34 KPa (59 psi +/- 5 psi).
CAUTION: Stop all actuation tests before proceeding.
Is the fuel pressure within specification?
Yes
- Repair or replace fuel supply line as necessary.
- Perform the PCM Verification Test. (Refer to 9 - ENGINE - STANDARD PROCEDURE)
No
- Go to 4
4.SADDLE FUEL TANK
Is the vehicle equipped with a saddle type fuel tank?
Yes
- Go to 5
No
- Go to 6
5.FUEL TANK SIPHON HOSE OR FUEL LINE RESTRICTED OR DAMAGED
WARNING: The fuel system is under a constant pressure, even with the engine off. Before testing or servicing any fuel system hose, fitting or line, the fuel system pressure must be released. Failure to follow these instructions can result in personal injury or death.
Were any problems found?
Yes
- Repair as necessary.
- Perform the PCM Verification Test. (Refer to 9 - ENGINE - STANDARD PROCEDURE)
No
- Go to 6
6.FUEL PUMP INLET STRAINER
WARNING: The fuel system is under a constant pressure even with the engine off. Before testing or servicing any fuel system hose, fitting or line, the fuel system pressure must be released. Failure to follow these instructions can result in personal injury or death.
Were any problems found?
Yes
- Replace the Fuel Pump Inlet Strainer.
- Perform the PCM Verification Test. (Refer to 9 - ENGINE - STANDARD PROCEDURE)
No
- Replace the Fuel Pump Module.
- Perform the PCM Verification Test. (Refer to 9 - ENGINE - STANDARD PROCEDURE)
7.FUEL PUMP GROUND CIRCUIT OPEN OR HIGH RESISTANCE
NOTE: The test light should be illuminated and bright. Compare the brightness to that of a direct connection to the battery.
Is the test light illuminated and bright?
Yes
- Replace the Fuel Pump Module in accordance with the Service information.
- Perform the PCM Verification Test. (Refer to 9 - ENGINE - STANDARD PROCEDURE)
No
- Repair the Fuel Pump Ground circuit for an open circuit or high resistance.
- Perform the PCM Verification Test. (Refer to 9 - ENGINE - STANDARD PROCEDURE)