P2503-CHARGING SYSTEM OUTPUT LOW





For a complete wiring diagram Refer to Section 8W.


  • When Monitored:

    With the engine speed greater than 1157 RPM.

  • Set Condition:

    The PCM detects that battery voltage is 1 volt below charging goal voltage for 13.47 seconds. The PCM compares sensed battery voltage with the field driver on and off. If the voltages are the same, this code will set. One Trip Fault. Three good trips to turn off the MIL.


Possible Causes
 
EXCESSIVE RESISTANCE IN THE B(+) CIRCUIT BETWEEN THE GENERATOR AND THE BATTERY
 
EXCESSIVE RESISTANCE BETWEEN THE GENERATOR CASE AND GROUND
 
(K20) GEN FIELD CONTROL CIRCUIT SHORTED TO VOLTAGE
 
(K20) GEN FIELD CONTROL CIRCUIT SHORTED TO GROUND
 
(K20) GEN FIELD CONTROL CIRCUIT OPEN OR HIGH RESISTANCE
 
(A804) GEN SENSE CIRCUIT OPEN OR HIGH RESISTANCE
 
GENERATOR
 
POWERTRAIN CONTROL MODULE (PCM)
 


Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 9 - ENGINE - STANDARD PROCEDURE).



Diagnostic Test

1.DTC IS ACTIVE

NOTE: Inspect the vehicle for aftermarket accessories that may exceed the generator system output.


NOTE: Inspect the condition and tension of the generator belt before continuing.


NOTE: Inspect the battery before continuing.








Is the status Active for this DTC?

Yes
  • Go to 2


No

2.EXCESSIVE RESISTANCE IN THE B(+) CIRCUIT

WARNING: When the engine is operating, do not stand in direct line with the fan. Do not put your hands near the pulleys, belts, or fan. Do not wear loose clothing. Failure to follow these instructions can result in personal injury or death.


NOTE: Make sure all test equipment and cables are clear of any belts, pulleys, or other moving parts.





Is the voltage above 0.4 volts?

Yes


No
  • Go to 3

3.EXCESSIVE RESISTANCE BETWEEN THE GENERATOR CASE AND GROUND

WARNING: When the engine is operating, do not stand in direct line with the fan. Do not put your hands near the pulleys, belts, or fan. Do not wear loose clothing. Failure to follow these instructions can result in personal injury or death.


NOTE: Make sure all test equipment and cables are clear of any belts, pulleys, or other moving parts.





Is the voltage above 0.1 volts?

Yes


No
  • Go to 4

4.(K20) GEN FIELD CONTROL CIRCUIT SHORTED TO VOLTAGE









Is there any voltage present?

Yes


No
  • Go to 5

5.(K20) GEN FIELD CONTROL CIRCUIT SHORTED TO GROUND






Is the resistance below 100 ohms?

Yes


No
  • Go to 6

6.(K20) GEN FIELD CONTROL CIRCUIT OPEN OR HIGH RESISTANCE





Is the resistance below 5.0 ohms?

Yes
  • Go to 7


No

7.(A804) GEN SENSE CIRCUIT OPEN OR HIGH RESISTANCE





Is the resistance above 5.0 ohms?

Yes
  • Go to 8


No

8.GENERATOR






NOTE: The test light should be illuminated and bright when toggled on. Compare the brightness to that of a direct connection to the battery.



Does the test light toggle on and off correctly during the actuator test?

Yes


No
  • Go to 9

9.POWERTRAIN CONTROL MODULE (PCM)








Were any problems found?

Yes


No