P2301-IGNITION COIL 1 CIRCUIT HIGH





For a complete wiring diagram Refer to Section 8W


  • When Monitored:

    With the engine running and battery voltage greater than 10.4 volts.

  • Set Condition:

    The Powertrain Control Module (PCM) detects that the Coil 1 Control voltage is above the maximum acceptable value.


Possible Causes
 
INTERMITTENT DTC
 
(K19) COIL 1 CONTROL CIRCUIT SHORTED TO VOLTAGE
 
(K19) COIL 1 CONTROL CIRCUIT SHORTED TO THE (K344) FUSED MAIN RELAY OUTPUT CIRCUIT
 
(K19) COIL 1 CONTROL CIRCUIT OPEN OR HIGH RESISTANCE
 
IGNITION COIL 1
 
POWERTRAIN CONTROL MODULE (PCM)
 


Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 9 - ENGINE - STANDARD PROCEDURE)



Diagnostic Test

1.DTC IS ACTIVE




WARNING: When the engine is operating, do not stand in direct line with the fan. Do not put your hands near the pulleys, belts, or fan. Do not wear loose clothing. Failure to follow these instructions can result in personal injury or death.




Is the status Active for this DTC?

Yes
  • Go to 2


No

2.(K19) COIL 1 CONTROL CIRCUIT SHORTED TO VOLTAGE









Is there any voltage present?

Yes


No
  • Go to 3

3.(K19) COIL 1 CONTROL CIRCUIT SHORTED TO THE (K344) FUSED MAIN RELAY OUTPUT CIRCUIT






Is the resistance above 100 ohms?

Yes
  • Go to 4


No

4.(K19) COIL 1 CONTROL CIRCUIT OPEN OR HIGH RESISTANCE





Is the resistance below 5.0 ohms?

Yes
  • Go to 5


No

5.IGNITION COIL 1



WARNING: When the engine is operating, do not stand in direct line with the fan. Do not put your hands near the pulleys, belts, or fan. Do not wear loose clothing. Failure to follow these instructions can result in personal injury or death.





NOTE: The test light should blink each time the circuit is activated by the PCM.



Does the test light blink each time the circuit is activated by the PCM?

Yes


No
  • Go to 6

6.POWERTRAIN CONTROL MODULE (PCM)






Were any problems found?

Yes


No