P2123-ACCELERATOR PEDAL POSITION SENSOR 1 CIRCUIT HIGH





For a complete wiring diagram Refer to Section 8W


  • When Monitored:

    With the ignition on and battery voltage greater than 10.4 volts.

  • Set Condition:

    The PCM detects that the APP Sensor 1 input voltage is above the maximum acceptable value.


Possible Causes
 
INTERMITTENT DTC
 
(F856) 5 VOLT SUPPLY CIRCUIT SHORTED TO VOLTAGE
 
(K23) APP SIGNAL 1 CIRCUIT SHORTED TO VOLTAGE
 
(K23) APP SIGNAL 1 CIRCUIT SHORTED TO THE (F856) 5 VOLT SUPPLY CIRCUIT
 
(K23) APP SIGNAL 1 CIRCUIT SHORTED TO THE (K858) 5 VOLT SUPPLY CIRCUIT
 
(K23) APP SIGNAL 1 CIRCUIT OPEN OR HIGH RESISTANCE
 
(K167) SENSOR GROUND CIRCUIT OPEN OR HIGH RESISTANCE
 
ACCELERATOR PEDAL POSITION SENSOR
 
POWERTRAIN CONTROL MODULE (PCM)
 


Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 9 - ENGINE - STANDARD PROCEDURE)



Diagnostic Test

1.DTC IS ACTIVE

NOTE: Diagnose and repair any system voltage or sensor supply voltage DTCs before continuing with this test.



WARNING: When the engine is operating, do not stand in direct line with the fan. Do not put your hands near the pulleys, belts, or fan. Do not wear loose clothing. Failure to follow these instructions can result in personal injury or death.




Is the status Active for this DTC?

Yes
  • Go to 2


No

2.(F856) 5 VOLT SUPPLY CIRCUIT SHORTED TO VOLTAGE









Is there any voltage present?

Yes


No
  • Go to 3

3.(K23) APP SIGNAL 1 CIRCUIT SHORTED TO VOLTAGE





Is there any voltage present?

Yes


No
  • Go to 4

4.(K23) APP SIGNAL 1 CIRCUIT SHORTED TO THE (F856) 5 VOLT SUPPLY CIRCUIT





Is the resistance below 100 ohms?

Yes


No
  • Go to 5

5.(K23) APP SIGNAL 1 CIRCUIT SHORTED TO THE (K858) 5 VOLT SUPPLY CIRCUIT





Is the resistance below 100 ohms?

Yes


No
  • Go to 6

6.(K23) APP SIGNAL 1 CIRCUIT OPEN OR HIGH RESISTANCE






Is the resistance below 5.0 ohms?

Yes
  • Go to 7


No

7.(K167) SENSOR GROUND CIRCUIT OPEN OR HIGH RESISTANCE





Is the resistance below 5.0 ohms?

Yes
  • Go to 8


No

8.ACCELERATOR PEDAL POSITION SENSOR









Is the voltage below 1.0 volt with the jumper wire in place?

Yes


No
  • Go to 9

9.POWERTRAIN CONTROL MODULE (PCM)








Were any problems found?

Yes


No