P1628-SENSOR REFERENCE VOLTAGE CIRCUIT ERRATIC





For a complete wiring diagram Refer to Section 8W


  • When Monitored:

    With the ignition on.

  • Set Condition:

    The PCM detects an excessive voltage variation on the 5 volt supply circuit.


Possible Causes
 
INTERMITTENT DTC
 
5-VOLT SUPPLY CIRCUIT SHORTED TO VOLTAGE
 
5-VOLT SUPPLY CIRCUIT SHORTED TO GROUND
 
5-VOLT SUPPLY CIRCUIT OPEN OR HIGH RESISTANCE
 
ACCELERATOR PEDAL POSITION SENSOR
 
CAMSHAFT 1/1 POSITION SENSOR
 
MAP SENSOR
 
MANIFOLD FLOW VALVE
 
POWERTRAIN CONTROL MODULE (PCM)
 


Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 9 - ENGINE - STANDARD PROCEDURE)



Diagnostic Test

1.DTC IS ACTIVE


WARNING: When the engine is operating, do not stand in direct line with the fan. Do not put your hands near the pulleys, belts, or fan. Do not wear loose clothing. Failure to follow these instructions can result in personal injury or death.




Is the status Active for this DTC?

Yes
  • Go to 2


No

2.(K858) 5 VOLT SUPPLY CIRCUIT VOLTAGE








Select the appropriate response from the list below:

Voltage above 5.2 volts


Voltage between 4.8 and 5.2 volts
  • Go to 3


Voltage below 4.8 volts
  • Go to 4

3.ACCELERATOR PEDAL POSITION SENSOR









Is the voltage below 4.8 volts?

Yes


No
  • Go to 9

4.CAMSHAFT 1/1 POSITION SENSOR








Is the voltage above 4.8 volts?

Yes


No
  • Go to 5

5.MAP SENSOR








Is the voltage above 4.8 volts?

Yes


No
  • Go to 6

6.MANIFOLD FLOW VALVE








Is the voltage above 4.8 volts?

Yes


No
  • Go to 7

7.5-VOLT SUPPLY CIRCUIT SHORTED TO GROUND


NOTE: All sensors connected to the (K857) 5 volt supply circuit and the (K858) 5 volt supply circuit must be disconnected.







Is the resistance above 1000 ohms for both circuits?

Yes
  • Go to 8


No

8.5-VOLT SUPPLY CIRCUIT OPEN OR HIGH RESISTANCE

NOTE: All sensors connected to the (K857) 5 volt supply circuit and the (K858) 5 volt supply circuit must be disconnected.








Is the resistance below 5.0 ohms for all of the circuits?

Yes
  • Go to 9


No

9.POWERTRAIN CONTROL MODULE (PCM)










Were any problems found?

Yes


No