P0850-PARK/NEUTRAL SWITCH PERFORMANCE

For a complete wiring diagram Refer to Section 8W.


  • When Monitored:

    Continuously with the transmission in Park, Neutral, or Drive and not in Limp-in mode.

  • Set Condition:

    This code will set if the PCM detects an irrational Park/Neutral switch state. Two trip fault. Three good trips to turn off the MIL.


Possible Causes
 
INTERMITTENT DTC
 
P/N SIGNAL CIRCUIT SHORTED TO VOLTAGE OR GROUND
 
DTCS PRESENT IN THE TRANSMISSION CONTROL MODULE (TCM)
 
POWERTRAIN CONTROL MODULE (PCM)
 


Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 9 - ENGINE - STANDARD PROCEDURE).



Diagnostic Test

1.DTC IS ACTIVE


WARNING: When the engine is operating, do not stand in direct line with the fan. Do not put your hands near the pulleys, belts, or fan. Do not wear loose clothing. Failure to follow these instructions can result in personal injury or death.


NOTE: It may be necessary to test drive the vehicle in order to get this DTC to reset.




Is the status Active for this DTC?

Yes
  • Go to 2


No

2.DTCS PRESENT IN THE TRANSMISSION CONTROL MODULE (TCM)

NOTE: If the scan tool is unable to communicate with the TCM, or if there are related communication DTCs present, refer to the Communication Category and perform the appropriate diagnostic procedure.





Are there any DTCs present in the TCM?

Yes
  • Refer to the Transmission Category and perform the appropriate diagnostic procedure.


No
  • Go to 3

3.POWERTRAIN CONTROL MODULE (PCM)







Were any problems found?

Yes


No