P0129-BAROMETRIC PRESSURE OUT-OF-RANGE LOW





For a complete wiring diagram Refer to Section 8W.


  • When Monitored:

    With engine speed within 64 RPM of target idle, MAP sensor voltage between .04 volts and 4.96 volts, no vehicle speed, and the throttle closed.

  • Set Condition:

    Each time the PCM detects that the MAP sensor value is greater than a calibrated value for BARO, a counter is incremented. If the counter reaches a calibrated limit, the test fails. One trip fault. Three good trips to turn off the MIL.


Possible Causes
 
INTERMITTENT DTC
 
MAP SENSOR WIRING OR CONNECTORS
 
(F856) 5 VOLT SUPPLY CIRCUIT HIGH RESISTANCE
 
(K1) MAP SIGNAL CIRCUIT HIGH RESISTANCE
 
(K900) SENSOR GROUND CIRCUIT HIGH RESISTANCE
 
MAP SENSOR
 


Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 9 - ENGINE - STANDARD PROCEDURE)



Diagnostic Test

1.CHECKING THE MAP SENSOR OPERATION

NOTE: Diagnose and repair any MAP sensor circuit DTCs before continuing with this test.




Were any problems found?

Yes


No