P0111-INTAKE AIR TEMPERATURE SENSOR PERFORMANCE





For a complete wiring diagram Refer to Section 8W


  • When Monitored:

    With engine off time greater than 480 minutes and ambient temperature greater than – 7° C (19.4° F).

  • Set Condition:

    After a calibrated amount of cool down time, the PCM compares the AAT, ECT, and IAT Sensor values. If one sensor value is not within 10° C (18° F) of the other temperature sensors for two consecutive trips, a DTC will set. Three good trips to turn off the MIL.


Possible Causes
 
INTERMITTENT DTC
 
(K21) IAT SIGNAL CIRCUIT SHORTED TO VOLTAGE
 
(K21) IAT SIGNAL CIRCUIT SHORTED TO GROUND
 
(K21) IAT SIGNAL CIRCUIT SHORTED TO (K915) SENSOR GROUND CIRCUIT
 
(K21) IAT SIGNAL CIRCUIT OPEN OR HIGH RESISTANCE
 
(K915) SENSOR GROUND CIRCUIT OPEN OR HIGH RESISTANCE
 
INTAKE AIR TEMPERATURE SENSOR
 
POWERTRAIN CONTROL MODULE (PCM)
 


Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 9 - ENGINE - STANDARD PROCEDURE)



Diagnostic Test

1.DTC IS ACTIVE

NOTE: Diagnose any CAN - C Communication DTCs before continuing.







Is the status Active or Pending for this DTC?

Yes
  • Go to 3


No
  • Go to 2

2.INTAKE AIR TEMPERATURE






Is the Intake Air Temperature Sensor value within 10° C (18° F) of the other two sensor values?

Yes


No
  • Go to 3

3.(K21) IAT SIGNAL CIRCUIT SHORTED TO VOLTAGE









Is there any voltage present?

Yes


No
  • Go to 4

4.(K21) IAT SIGNAL CIRCUIT SHORTED TO GROUND






Is the resistance above 100 ohms?

Yes
  • Go to 5


No

5.(K21) IAT SIGNAL CIRCUIT SHORTED TO (K915) SENSOR GROUND CIRCUIT





Is the resistance above 100 ohms?

Yes
  • Go to 6


No

6.(K21) IAT SIGNAL CIRCUIT OPEN OR HIGH RESISTANCE





Is the resistance below 5.0 ohms?

Yes
  • Go to 7


No

7.(K915) SENSOR GROUND CIRCUIT OPEN OR HIGH RESISTANCE





Is the resistance below 5.0 ohms?

Yes
  • Go to 8


No

8.INTAKE AIR TEMPERATURE SENSOR









Is the voltage below 1.0 volt with the jumper wire in place?

Yes


No
  • Go to 9

9.POWERTRAIN CONTROL MODULE (PCM)








Were any problems found?

Yes


No