U0146–LOST COMMUNICATION WITH CENTRAL GATEWAY

For a complete wiring diagram Refer to Section 8W.


  • When Monitored:
    • With the ignition on
    • Battery voltage between 10 and 16 volts
    • IOD fuse installed
  • Set Condition:

    If the Anti-Lock Brakes Module either fails to receive bus messages from the Totally Integrated Control Module (TIPM) for approximately 500 ms, or it receives invalid messages from the TIPM, or it detects messages from the TIPM are of improper data length.


Possible Causes
 
DTCs RELATED TO BATTERY VOLTAGE, IGNITION, OR VIN MESSAGES
 
CAN C BUS CIRCUITS OPEN OR SHORTED
 
TIPM POWER AND GROUND
 
TIPM
 
ANTI-LOCK BRAKES MODULE
 




Diagnostic Test

1.VERIFY DTC IS ACTIVE

NOTE: Verify the IOD fuse is installed and battery voltage is between 10 and 16 volts before proceeding.









Does this DTC reset?

Yes
  • Go To 2


No

2.CHECK FOR ANY OF THE FOLLOWING ACTIVE DTCs


NOTE: Check for CAN C hardware electrical, VIN Missing/Mismatch, battery or ignition related DTCs.



Does the scan tool display any active DTCs related to the conditions listed above?

Yes
  • Diagnose and repair the DTC(s). Refer to the Table of Contents in the applicable Section.


No
  • Go To 3

3.VERIFY THAT THE TIPM IS ACTIVE ON THE BUS




Is the TIPM active on the bus?

Yes
  • Go To 4


No

4.CHECK FOR ADDITIONAL COMMUNICATION RELATED DTCs



Is there more than one module with active DTCs “Logged Against” the TIPM?

Yes


No