C2205–STEERING ANGLE SENSOR INTERNAL
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
With ignition on, but not if supply voltage faults are detected.
- Set Condition:
If the Anti-Lock Brakes Module detects that the Steering Angle Sensor sends an internal failure message.
| Possible Causes |
| STEERING ANGLE SENSOR |
Diagnostic Test
1.CHECK FOR A DTC C2205-STEERING ANGLE SENSOR INTERNALNOTE: This DTC must be active for the results of this test to be valid.
WARNING: Ensure brake capability is available before road testing.
Does the scan tool display: C2205-STEERING ANGLE SENSOR INTERNAL?
Yes
- Replace the Steering Angle Sensor in accordance with the Service Information.
- Perform ABS VERIFICATION TEST. (Refer to 5 - BRAKES - STANDARD PROCEDURE).
No
- Refer to the INTERMITTENT CONDITION diagnostic procedure.
- Perform ABS VERIFICATION TEST. (Refer to 5 - BRAKES - STANDARD PROCEDURE).