U1415-IMPLAUSIBLE/MISSING VEHICLE CONFIGURATION RECEIVED

For a complete wiring diagram Refer to Section 8W

When Monitored:
Continuously with the ignition on.
Set Condition:
When the All Wheel Drive (AWD) Module detects an incorrect CAN messages from the Engine Control Module (ECM) or the Totally Integrated Power Module (TIPM).

Possible Causes

TOTALLY INTEGRATED POWER MODULE (TIPM) NOT CONFIGURED CORRECTLY

TIPM CAN BUS DTCS

ENGINE DTCS

ALL WHEEL DRIVE (AWD) CONTROL MODULE

1.CHECK IF TIPM CAN BUS DTC'S ARE PRESENT

Are there any TIPM CAN BUS DTC's present?

Yes

Refer to 8-ELECTRICAL/ELECTRONIC CONTROL MODULES - DIAGNOSIS AND TESTING and diagnose the appropriate symptom.
Perform AWD VERIFICATION TEST - VER 1. (Refer to 3 - DIFFERENTIAL & DRIVELINE/ELECTRONICALLY CONTROLLED CLUTCH - STANDARD PROCEDURE)

2.CHECK IF ENGINE DTC'S ARE PRESENT

Are there any Engine DTC's present?

Yes

Refer to the 9 - ENGINE ELECTRICAL DIAGNOSTICS and diagnose the appropriate symptom.
Perform AWD VERIFICATION TEST - VER.

Using the schematics as a guide, check the AWD Module pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the AWD Module per the Service Information.
Perform AWD VERIFICATION TEST - VER. (Refer to 3 - DIFFERENTIAL & DRIVELINE/ELECTRONICALLY CONTROLLED CLUTCH - STANDARD PROCEDURE)