B2207-OCCUPANT RESTRAINT CONTROLLER INTERNAL 1

For a complete wiring diagram Refer to Section 8W.


  • When Monitored:

    With the ignition on. The module's on board diagnostics continuously performs internal circuit tests.

  • Set Condition:

    This DTC will set if the module identifies an out of range internal circuit.


Possible Causes
  
OCCUPANT RESTRAINT CONTROLLER (ORC)
  



Diagnostic Test

1.REPLACE OCCUPANT RESTRAINT CONTROLLER



WARNING: To avoid personal injury or death, turn the ignition off, disconnect the battery and wait two minutes before proceeding.


WARNING: If the Occupant Restraint Controller is dropped at any time, it must be replaced. Failure to take proper precautions could result in accidental airbag deployment and personal injury or death.





Repair
  • Replace the ORC in accordance with the Service Information.
  • Perform *AIRBAG SYSTEM VERIFICATION TEST - VER 1.