B1BAA-OCCUPANT CLASSIFICATION MODULE CONFIGURATION MISMATCH





For a complete wiring diagram Refer to Section 8W.


  • When Monitored:

    While the CAN bus ignition status is IGN_RUN.

  • Set Condition:

    This DTC will set if the ORC is not configured for Occupant Classification Module and the OCM is active on the CAN Bus. Note: Because all ORCs are originally configured for the OCM the ORC must learn the not equipped with OCM state from the TIPM.


Possible Causes
 
LOSS OF COMMUNICATION BETWEEN ORC AND TIPM
 
MISSING CAN BUS CONFIGURATION MESSAGE
 
CORRUPT CONFIGURATION MESSAGE
 
OCCUPANT RESTRAINT CONTROLLER (ORC)
 



1.CHECK FOR ACTIVE B1BAA-OCCUPANT CLASSIFICATION MODULE CONFIGURATION MISMATCH



Does the scan tool display an active: B1BAA-OCCUPANT CLASSIFICATION MODULE CONFIGURATION MISMATCH DTCs?

Yes
  • Go To 2


No
  • Go To 5

2.CHECKING FOR CORRUPT CONFIGURATION MESSAGE



Does the scan tool display an active: U1414-IMPLAUSIBLE/MISSING ECU NETWORK CONFIGURATION DATA DTCs?

Yes
  • Perform the U1414-IMPLAUSIBLE/MISSING ECU NETWORK CONFIGURATION DATA diagnostic test.


No
  • Go To 3

3.CHECKING FOR LOSS OF CAN BUS CONFIGURATION MESSAGE



Does the scan tool display an active U1415-IMPLAUSIBLE/MISSING VEHICLE CONFIGURATION DATA DTCs?

Yes
  • Perform the U1415-IMPLAUSIBLE/MISSING VEHICLE CONFIGURATION DATA diagnostic test.


No
  • Go To 4

4.CHECKING FOR LOSS OF COMMUNICATION WITH THE TIPM



Does the scan tool display an active: U0141-LOST COMMUNICATION WITH FRONT CONTROL MODULE (TOTALLY INTEGRATED POWER MODULE)?

Yes


No
  • Go To 6

5.VERIFYING STORED B1BAA-OCCUPANT CLASSIFICATION MODULE CONFIGURATION MISMATCH DTC





Does the scan tool display an active or stored B1BAA-OCCUPANT CLASSIFICATION MODULE CONFIGURATION MISMATCH DTCs?

Yes
  • For active DTC-Go To 2


Yes
  • For stored-Go To 6


No
  • Perform *OCM SYSTEM VERIFICATION TEST.

6.REPLACE THE ORC

WARNING: To avoid personal injury or death, turn the ignition off, disconnect the battery and wait two minutes before proceeding.


WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment and personal injury or death.


NOTE: When reconnecting airbag system components the Ignition must be turned off and the Battery must be disconnected.





Repair
  • Replace the ORC in accordance with the Service Information.
  • Perform *OCM SYSTEM VERIFICATION TEST.