B2105-IGNITION RUN/START CONTROL CIRCUIT HIGH





For a complete wiring diagram Refer to Section 8W.


  • When Monitored:

    With the ignition on.

  • Set Condition:

    (F200) Fused Ignition Switch Output (Run-Start) circuit high.


Possible Causes
  
(F200) FUSED IGNITION SWITCH OUTPUT (RUN-START) CIRCUIT SHORT TO VOLTAGE
  
(F202) FUSED IGNITION SWITCH OUTPUT (RUN-START) CIRCUIT SHORT TO VOLTAGE
  
ORC
  
TIPM
  



Diagnostic Test

1.CHECK FOR ACTIVE DTC





Does the scan tool display this DTC as active?

Yes
  • Go To 2


No
  • If the DTC is stored, check for an intermittent condition. Using the wiring diagram/schematic as a guide, visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals.

2.ORC INTERNAL SHORT TO VOLTAGE


WARNING: To avoid personal injury or death, turn the ignition off, disconnect the battery and wait two minutes before proceeding.







Does the scan tool display this DTC as active?

Yes
  • Go To 3


No

3.(F200) FUSED IGNITION SWITCH OUTPUT (RUN-START) CIRCUIT SHORT TO VOLTAGE








Is the voltage above 10 volts ?

Yes


No
  • Go To 4

4.(F202) FUSED IGNITION SWITCH OUTPUT (RUN-START) CIRCUIT SHORT TO VOLTAGE








Is the voltage above 10 volts ?

Yes


No