P1729-TRANSMISSION RATIO CONTROL CIRCUIT

For a complete wiring diagram Refer to Section 8W.

Theory of Operation


The Transmission Control Module monitors and controls the gear ratio by the use of a Step motor that transfers electrical power to mechanical movement. The rationality is a continuous test that monitors the Step motor movement. If the Step motor ON/OFF status does not match the TCM requested ON/OFF status a DTC will set.


  • When Monitored:

Ignition on with a system voltage between 9.0 and 16.0 volts.

  • Set Condition:

    If the Step motor ON/OFF status does not match the TCM requested ON/OFF status for the period of 200 msec the DTC will set. It takes two consecutive problem identification trips to illuminate the MIL.


Possible Causes
 
(T314) A, (T315) B, (T316) C, AND/OR (T317) D STEP MOTOR CONTROL CIRCUIT(S) SHORT TO VOLTAGE
 
(T314) A, (T315) B, (T316) C, AND/OR (T317) D STEP MOTOR CONTROL CIRCUIT(S) OPEN
 
(T314) A, (T315) B, (T316) C, AND/OR (T317) D STEP MOTOR CONTROL CIRCUIT(S) SHORT TO GROUND
 
STEP MOTOR
 
TRANSMISSION CONTROL MODULE
 


Always perform the CVT Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - CVT - STANDARD PROCEDURE)



Diagnostic Test

1.CHECK TO SEE IF THE DTC IS ACTIVE



Is the status Active for this DTC or is the STARTS SINCE SET counter 2 or less?

Yes
  • Go To 2


No
  • Go To 6

2.CHECK THE (T314) A, (T315) B, (T316) C, AND (T317) D STEP MOTOR CONTROL CIRCUIT(S) FOR A SHORT TO VOLTAGE









Is the voltage above .05 volts for any of the Step Motor Control circuits?

Yes


No
  • Go To 3

3.CHECK THE (T314) A, (T315) B, (T316) C, AND (T317) D STEP MOTOR CONTROL CIRCUIT(S) FOR AN OPEN






Is the resistance above 5.0 ohms for any of the Step Motor Control circuits?

Yes


No
  • Go To 4

4.CHECK THE (T314) A, (T315) B, (T316) C, AND (T317) D STEP MOTOR CONTROL CIRCUIT(S) FOR A SHORT TO GROUND





Is the resistance below 5.0 ohms for any of the Step Motor Control circuits?

Yes


No
  • Go To 5

5.TRANSMISSION CONTROL MODULE

(Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - CVT - STANDARD PROCEDURE)

During the verification test did the DTC reset?

Yes


No
  • Test Complete.

6.INTERMITTENT WIRING AND CONNECTORS





Were there any problems found?

Yes


No
  • Test Complete.