P0826-UP/DOWN SHIFT SWITCH CIRCUIT





For a complete wiring diagram Refer to Section 8W.

Theory of Operation


The AutoStick function allows the driver to manually change the gear ratio to a locked ratio. The Transmission Control Module (TCM) monitors the AutoStick Upshift and Downshift circuits. If the TCM receives an Upshift and Downshift request simultaneously, or manual mode Upshift/Downshift request while other than in the D-Range, a DTC will set.


  • When Monitored:

    Ignition on with a system voltage between 9.0 and 16 volts.

  • Set Condition:

    Upshift and Downshift requested simultaneously while in the Drive position or the Upshift and/or Downshift request during while not in the Drive position for the period of 1.0 second.


Possible Causes
 
(T5) AUTOSTICK UPSHIFT SWITCH SIGNAL CIRCUIT SHORT TO GROUND
 
(T44) AUTOSTICK DOWNSHIFT SWITCH SIGNAL CIRCUIT SHORT TO GROUND
 
SHIFT LEVER ASSEMBLY
 
TRANSMISSION CONTROL MODULE
 


Always perform the CVT Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - CVT - STANDARD PROCEDURE)



Diagnostic Test

1.CHECK IF THE DTC IS ACTIVE





Is the status Active for this DTC or is the STARTS SINCE SET counter 2 or less?

Yes
  • Go To 2


No
  • Go To 7

2.VERIFY PROBLEM



Does the scan tool show either the upshift or downshift as true with the shifter in the center position (pick best answer)?

Upshift shows as true
  • Go To 3


Downshift shows as true
  • Go To 5


Neither circuit shows as true
  • Using the schematics as a guide, check the Transmission Control Module (TCM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. Check for any Service Bulletins for possible causes that may apply. If no problems are found, replace the TCM per the Service Information.
  • Perform CVT VERIFICATION TEST. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - CVT - STANDARD PROCEDURE)

3.CHECK THE SHIFT LEVER ASSEMBLY






Does the Upshift still show as true?

Yes
  • Go To 4


No

4.CHECK THE (T5) AUTOSTICK UPSHIFT SWITCH SIGNAL CIRCUIT FOR A SHORT TO GROUND







Is the resistance below 5.0 ohms?

Yes


No
  • Using the schematics as a guide, check the Transmission Control Module (TCM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. Check for any Service Bulletins for possible causes that may apply. If no problems are found, replace the TCM per the Service Information.
  • Perform CVT VERIFICATION TEST. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - CVT - STANDARD PROCEDURE)

5.CHECK THE SHIFT LEVER ASSEMBLY






Does the Downshift still show as true?

Yes
  • Go To 6


No

6.CHECK THE (T44) AUTOSTICK DOWNSHIFT SWITCH SIGNAL CIRCUIT FOR A SHORT TO GROUND







Is the resistance below 5.0 ohms?

Yes


No
  • Using the schematics as a guide, check the Transmission Control Module (TCM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. Check for any Service Bulletins for possible causes that may apply. If no problems are found, replace the TCM per the Service Information.
  • Perform CVT VERIFICATION TEST. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - CVT - STANDARD PROCEDURE)

7.INTERMITTENT WIRING AND CONNECTORS





Were there any problems found?

Yes


No
  • Test Complete.