P0741-TORQUE CONVERTER CLUTCH CIRCUIT PERFORMANCE

Theory of Operation


The Transmission Control Module (TCM) monitors the Torque Convertor Clutch for slippage using a calculation derived from turbine revolution (input speed) and engine rpm broadcast over the CAN C BUS. If the slip value exceeds a predetermined value the DTC will set.


  • When Monitored:

    Ignition on, engine running with the transmission in a valid forward gear.

    System voltage between 9.0 and 16.0 volts.

    Vehicle speed greater than 10 Km/h (6 mph).

    Accelerator Pedal Position (APP) greater than 12.5%.

    Engine rpm greater than 450 rpm with TCC lock-up enabled.

    TCC Lock up command is ON (True).

    No active DTCs from the following:

  • Step motor,
  • Line Pressure Solenoid
  • Secondary Solenoid
  • Input or Output Speed Sensor
  • Primary or Secondary Pressure Sensor
  • CAN Bus
  • Set Condition:

    The DTC is detected If the Torque Convertor Clutch (TCC) slip monitored by the Transmission Control Module (TCM) is greater than a predetermined value for the period of 30 seconds. Note: This is not an electrical fault but a mechanical malfunction such as a control valve sticking in its bore or a TCC Solenoid hydraulic malfunction. It takes two consecutive problem identification trips for the DTC to mature and illuminate the MIL.


Possible Causes
 
TORQUE CONVERTOR HYDRAULIC CIRCUIT
 
TORQUE CONVERTOR CLUTCH SOLENOID
 
TORQUE CONVERTOR CLUTCH
 
TRANSMISSION CONTROL MODULE
 


Always perform the CVT Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - CVT - STANDARD PROCEDURE)



Diagnostic Test

1.CHECK TO SEE IF THE DTC IS ACTIVE




NOTE: This can not be performed on a hoist, actual road conditions must be present for proper results.



Did the DTC reset (one trip) during the road test?

Yes


No
  • Go To 2

2.INTERMITTENT CONDITION





Were there any problems found or did the DTC reset?

Yes


No
  • Test Complete.