B1096-FRONT RIGHT SEAT HEATER CONTROL CIRCUIT LOW





For a complete wiring diagram Refer to Section 8W.


  • When Monitored:

    Ignition on, during the heated seat operation.

  • Set Condition:

    This code is set immediately after the Heated Seat Module detects the control circuit shorted to ground.


Possible Causes
 
(P188) RIGHT SEAT HEATER B(+) DRIVER SHORTED TO GROUND
 
SEAT CUSHION HEATER ELEMENT SHORTED
 
SEAT BACK HEATER ELEMENT SHORTED
 
HEATED SEAT MODULE
 




Diagnostic Test

1.VERIFY THAT DTC B1096-FRONT RIGHT SEAT HEATER CONTROL CIRCUIT LOW IS ACTIVE





Does the DTC B1096 – FRONT RIGHT SEAT HEATER CONTROL CIRCUIT LOW reset?

Yes
  • Go To 2


No
  • The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
  • Perform BODY VERIFICATION TEST – VER 1. (Refer to BODY VERIFICATION TEST – VER 1).

2.DISCONNECT RIGHT CUSHION HEATER 2-WAY CONNECTOR AND READ DTC'S




NOTE: Check connectors - Clean and repair as necessary.






Does the scan tool display the same DTC?

Yes
  • Go To 5


No
  • Go To 3

3.CHECK THE (P188) RIGHT SEAT HEATER B(+) DRIVER FOR A SHORT TO GROUND AT THE SEAT





Is the resistance below 1000 ohms?

No
  • Go To 4


Yes

4.CHECK THE RIGHT HEATER ELEMENT SEAT CUSHION AND SEAT BACK RESISTANCE








Is the resistance correct for each heater element?

Yes
  • Using the wiring diagram/schematic as a guide, inspect the wiring and connectors for an intermittent short to ground.


No

5.CHECK THE (P188) RIGHT SEAT HEATER B(+) DRIVER CIRCUIT FOR A SHORT TO GROUND





NOTE: Check connectors - Clean and repair as necessary.




Is the resistance below 5.0 ohms?

Yes


No