BODY VERIFICATION TEST – VER 1



Diagnostic Test

1.Perform Body Verification Test

NOTE: If the SKREEM or PCM/ECM was replaced, refer to the service information for proper programming procedures.

  • Disconnect all jumper wires and reconnect all previously disconnected components and connectors.
  • Ensure that all accessories are turned off.
  • Ensure that the battery is fully charged.
  • Turn the ignition on.
  • With the scan tool, record and erase DTC's from all modules.
  • If an electronic control module was replaced, select the applicable module from the scan tool menu and press “Misc. Functions”. If the module has programmable features, program as necessary.
  • (Export only) If the Intrusion Transceiver Module (ITM) and/or Siren was replaced, select ITM from the scan tool ECU View menu then “Misc. Functions” and perform the applicable replacement procedure.
  • Turn the ignition off, wait 10 seconds, and then turn the ignition on.
  • Operate all functions of the system that caused the original concern.
  • With the scan tool, select ECU View and check for DTC's in the modules.


Are DTCs present in any of the modules or is the original condition still present?

Yes
  • The repair is not complete. Refer to the related category for the DTC or symptom that is still present.


No
  • The repair is complete.