P128C-TCM POWER CONTROL CIRCUIT 2 HIGH - TIPM
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
With the ignition on. Battery voltage greater than 10 volts.
- Set Condition:
A shorted condition is detected in the TIPM Transmission Control Output circuit.
| Possible Causes |
| (T16) TRANSMISSION CONTROL OUTPUT CIRCUIT SHORT TO VOLTAGE |
| TOTALLY INTEGRATED POWER MODULE (TIPM) |
Always perform the CVT Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - CVT - STANDARD PROCEDURE)
Diagnostic Test
1.CHECK IF THE DTC IS ACTIVEIs the status Active for this DTC?
Yes
- Go to 2
No
- Go to 4
2.(T16) TRANSMISSION CONTROL OUTPUT CIRCUIT SHORT TO VOLTAGE
Is the voltage above 10.0 volts?
Yes
- Repair the (T16) Transmission Control Output circuit for a short to voltage.
- Perform CVT VERIFICATION TEST. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - CVT - STANDARD PROCEDURE)
No
- Go to 3
3.TOTALLY INTEGRATED POWER MODULE
Were there any problems found?
Yes
- Repair as necessary.
- Perform CVT VERIFICATION TEST. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - CVT - STANDARD PROCEDURE)
No
- Replace the Totally Integrated Power Module per Service Information.
- Perform CVT VERIFICATION TEST. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - CVT - STANDARD PROCEDURE)
4.INTERMITTENT WIRING AND CONNECTORS
Were any problems found?
Yes
- Repair as necessary.
- Perform CVT VERIFICATION TEST. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - CVT - STANDARD PROCEDURE)
No
- Test complete.