C2206–VEHICLE CONFIGURATION MISMATCH
For a complete wiring diagram Refer to Section 8W
- When Monitored:
With the ignition on.
- Set Condition:
When the Anti-Lock Brake Module detects the signal from the gateway module relevant for vehicle characteristic is missing or does not match for a period greater than the specified fault duration.
| Possible Causes |
| TIPM / PCM NOT CONFIGURED CORRECTLY |
| ANTI-LOCK BRAKE MODULE |
Diagnostic Test
1.CHECK FOR A DTC C2206-VEHICLE CONFIGURATION MISMATCHNOTE: This DTC must be active for the results of this test to be valid.
NOTE: This DTC will be active when a new module is installed until initialization is performed.
(Refer to 5 - BRAKES - STANDARD PROCEDURE)
Does the scan tool display: C2206-VEHICLE CONFIGURATION MISMATCH?
Yes
- Go To 2
No
- Perform the ABS Intermittent Condition diagnostic procedure in this Section.
- Refer to the ABS-INTERMITTENT CONDITION TEST. (Refer to 5 - BRAKES - DIAGNOSIS AND TESTING)
2.VERIFY THAT THE TIPM/PCM IS CONFIGURED CORRECTLY
NOTE: The DTC will be active when a new controller is installed until initialization is performed.
Was the TIPM/PCM configured correctly?
Yes
- Replace the Anti-Lock Brake Module in accordance with the Service Information.
- Perform ABS VERIFICATION TEST. (Refer to 5 - BRAKES - STANDARD PROCEDURE).
No
- Reprogram the appropriate module.
- Perform ABS or PCM VERIFICATION TEST. (Refer to 5 - BRAKES - STANDARD PROCEDURE).