P1793-TRD LINK COMMUNICATION ERROR





For a complete wiring diagram Refer to Section 8W.

Theory of Operation


Engine Torque Management is used during heavy throttle, high-torque, high speed 1-2, 2-3, 4-2, and 3-1 shifts in order to reduce the energy dissipation in the 2-4 and OD clutches to an acceptable level. The Engine Control Module is expected to respond to a torque management test or request by transmitting a message over the communication bus to the Transmission Control Module.


  • When Monitored:

    During torque managed shifts with Throttle angle above 54 degrees. This system is also tested whenever the vehicle is stopped and the engine speed is below 1000 RPM.

  • Set Condition:

    This code is set when the Transmission Control Module sends two subsequent Torque Reduction messages (pulses the Torque Management Request Sense circuit to ground) to the Engine Control Module via the Torque Management Request Sense circuit and the TCM does not receive a confirmation from the ECM over the communication bus.


Possible Causes
 
RELATED DTC'S PRESENT
 
TORQUE MANAGEMENT REQUEST SENSE CIRCUIT OPEN
 
TORQUE MANAGEMENT REQUEST SENSE CIRCUIT SHORT TO GROUND
 
TORQUE MANAGEMENT REQUEST SENSE CIRCUIT SHORTED TO VOLTAGE
 
ENGINE CONTROL MODULE
 
TRANSMISSION CONTROL MODULE
 


Always perform the 45RFE/545RFE Pre-Diagnostic Troubleshooting Procedure before proceeding. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - 45RFE/545RFE - STANDARD PROCEDURE)



Diagnostic Test

1.CHECK FOR RELATED DTCS



Are any of the DTCs P1694, P0731, P0732, P0733, P0734, and/or P1736 present also?

Yes


No
  • Go To2

2.CHECK TO SEE IF DTC P1793 IS CURRENT


NOTE: NOTE: This counter only applies to the last DTC set.



Is the STARTS SINCE SET counter set at 2 or less?

Yes
  • Go To3


No
  • Go To7

3.TORQUE MANAGEMENT REQUEST SENSE CIRCUIT OPEN








Is the resistance above 5.0 ohms?

Yes


No
  • Go To4

4.TORQUE MANAGEMENT REQUEST SENSE CIRCUIT SHORT TO GROUND





Is the resistance below 5.0 ohms?

Yes


No
  • Go To5

5.TORQUE MANAGEMENT REQUEST SENSE CIRCUIT SHORT TO VOLTAGE






Is the voltage above 10.5 volts?

Yes


No
  • Go To6

6.TRANSMISSION CONTROL MODULE



Is the voltage above 7.0 volts?

Yes
  • Using the schematics as a guide, check the Transmission Control Module (TCM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the TCM per the Service Information. With the scan tool, perform QUICK LEARN.
  • Perform 45RFE/545RFE TRANSMISSION VERIFICATION TEST - VER 1. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - 45RFE/545RFE - STANDARD PROCEDURE)


No
  • Using the schematics as a guide, check the Powertrain Control Module (ECM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the ECM per the Service Information. With the scan tool, perform QUICK LEARN.
  • Perform 45RFE/545RFE TRANSMISSION VERIFICATION TEST - VER 1. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - 45RFE/545RFE - STANDARD PROCEDURE)

7.INTERMITTENT WIRING AND CONNECTORS







Where there any problems found?

Yes


No
  • Test Complete.