INSTALLATION



NOTE: Pinion depth shims are located under the rear pinion bearing. If ring and pinion gears are reused, the pinion oil slinger/depth shim should not require replacement. Refer to Adjustments (Pinion Gear Depth) to select the proper thickness shim before installing pinion gear.












new



newDo not over-tighten.

CAUTION: Never loosen pinion gear nut to decrease pinion rotating torque and never exceed specified preload torque. Failure to follow these instructions will result in damage.






  • Original Bearings: 1 - 2.2 N·m (10 - 20 in. lbs.).
  • New Bearings: 1.7 - 2.8 N·m (15 - 25 in. lbs.).




new

CAUTION: Never reuse the ring gear bolts. Failure to follow these instructions will result in damage.



Total Torque to Rotate is, pinion torque to rotate plus:

  • Gear Ratio 3.55: 0.48 - 0.78 N·m (4.2 - 6.9 in. lbs.)
  • Gear Ratio 3.73: 0.45 - 0.75 N·m (3.9 - 6.6 in. lbs.)

    If TTR is high, decrease shim thickness equally on both sides of the differential and check TTR again. If TTR is low, increase shim thickness equally on both sides of the differential and check TTR again.